Charge Controllers

Solar Charge Controller 10 Amp – 12v/24v PWM

₨ 2,500PKR · price may vary

Model: SOCC - 01
Specifications: 2

Ampere10 Amp
Voltage12v/24v

Overview

OVERVIEW:LCD/LED displayPWM battery chargingAll necessary protection equippedAdjustable controlling parameter of the system

Specifications

POWER
Ampere	10 Amp
General Specification
Voltage	12v/24v

How to read this datasheet

Solar Charge Controller 10 Amp – 12v/24v PWM is listed with 2 published specifications, including ampere of 10 Amp and voltage of 12v/24v. Those figures are what decide whether this unit fits your system, so read them against the equipment it will connect to before comparing price.

For a charge controller, the figures that matter most are whether it offers a load output, temperature compensation and remote monitoring, type: MPPT or PWM, rated charge current in amps, which must exceed the array's short-circuit current with margin and maximum PV open-circuit voltage, the hard limit that must survive cold-morning Voc rise. In any system with a battery and a separate array, the controller is what protects the most expensive component and determines how much of the array's output actually reaches storage.

Choosing a charge controller: the checks that matter

The checks below apply to any charge controller. Run them against the specification table above — most disappointing solar purchases are compatible-on-paper units that fail one of these in practice.

Confirm the controller supports your battery chemistry with the right charge profile. Lithium, AGM, gel and flooded batteries need different absorption and float voltages.
Prefer a unit with temperature compensation or a battery temperature sensor if the bank lives somewhere that gets hot or cold.
Choose MPPT over PWM for anything beyond a very small array. An MPPT controller harvests roughly 20–30% more energy because it converts excess panel voltage into charge current instead of throwing it away.
Size the current rating from array watts divided by battery voltage, then add at least 25% margin for cold, bright conditions where panels exceed their rated output.

Common mistakes

Sizing on rated array watts alone and ignoring the voltage ceiling, which is the most common way controllers are killed.
Using a PWM controller with a high-voltage grid-tie panel — the voltage mismatch wastes a large share of the panel's output.
Running the load output beyond its rating instead of wiring heavy loads directly to the battery through a fuse.

Price and availability

Solar Charge Controller 10 Amp – 12v/24v PWM is listed at ₨ 2,500 (PKR). Solar pricing moves with supply, import duties and exchange rates, and distributors set their own margins, so treat this as a comparison reference and confirm the current figure before you order.

SolarBazaar compares equipment rather than selling it. Shortlist here on specification and price, then buy from an authorised distributor or installer in your country: warranty cover on solar hardware is normally honoured through the channel you bought from.

Solar Charge Controller 10 Amp – 12v/24v PWM — frequently asked questions

How much does Solar Charge Controller 10 Amp – 12v/24v PWM cost?

Solar Charge Controller 10 Amp – 12v/24v PWM is listed at ₨ 2,500 (PKR). The figure is indicative — solar prices move with supply, duties and exchange rates, and each distributor sets its own margin — so confirm the current price with a supplier before ordering.

What are the specifications of Solar Charge Controller 10 Amp – 12v/24v PWM?

We hold 2 published specifications for this charge controller, including ampere 10 Amp and voltage 12v/24v. The full table is on this page, listed under model SOCC - 01.

Is Solar Charge Controller 10 Amp – 12v/24v PWM right for my system?

That depends on what it has to connect to. For a charge controller, check whether it offers a load output, temperature compensation and remote monitoring, type: MPPT or PWM and rated charge current in amps, which must exceed the array's short-circuit current with margin against the rest of your equipment before price enters the decision. Check the maximum PV input voltage against the array's Voc at your coldest expected temperature, not at 25 °C — Voc rises as temperature falls, and exceeding the limit destroys the controller instantly.

Where can I buy Solar Charge Controller 10 Amp – 12v/24v PWM?

SolarBazaar lists and compares equipment rather than selling it. Use the specifications and price here to shortlist, then buy through an authorised distributor or installer — buying in-channel is what keeps the manufacturer's warranty valid.

Reviews

No reviews yet

Be the first to review this product.