Charge Controllers
Charge Controllers
MIDNITE Classic 200 MPPT Charge Controller
₨ 80,000PKR · price may vary
BrandMIDNITE Classic- Model
- SCMN-02
- Specifications
- 6
- Battery VoltageCharge: 12-93 Volts
- Derated Currentat 40°C (104°F): 66 Amps
- Current OutputMax at 25°C (77°F): 74A @ 12V | 70A @ 24V | 65A @ 48V
- Environment-40°C to 40°C (-40°F to 104°F)
- Input VoltageOperating: 200VDC
- View all 6 specifications ↓
Overview
OVERVIEW:The Classic 200 MPPT Charge Controller has Arc Fault, Ground Fault, free web monitoring, a graphics panel and Solar, Hydro and Wind Modes. The Classic 200 has a maximum output current of 79 amps, an operating voltage of 200 volts and works with 12 to 72 volt battery systems. The FREE MidNit
Specifications
| TECHNICAL SPECIFICATION | |
|---|---|
| Battery Voltage | Charge: 12-93 Volts |
| Derated Current | at 40°C (104°F): 66 Amps |
| General Specification | |
| Current Output | Max at 25°C (77°F): 74A @ 12V | 70A @ 24V | 65A @ 48V |
| Environment | -40°C to 40°C (-40°F to 104°F) |
| Input Voltage | Operating: 200VDC |
| Dimensions | 14.87" x 5.95" x 4.00" (378mm x 151mm x 102mm) |
Reading the specifications
MIDNITE Classic 200 MPPT Charge Controller is listed with 6 published specifications from MIDNITE Classic, including battery voltage of Charge: 12-93 Volts, derated current of at 40°C (104°F): 66 Amps, current output of Max at 25°C (77°F): 74A @ 12V | 70A @ 24V | 65A @ 48V and environment of -40°C to 40°C (-40°F to 104°F). Those figures are what decide whether this unit fits your system, so read them against the equipment it will connect to before comparing price.
For a charge controller, the figures that matter most are supported battery voltages (12/24/36/48 V) and chemistries, conversion efficiency, typically 96–99% for a good MPPT unit, whether it offers a load output, temperature compensation and remote monitoring and type: MPPT or PWM. In any system with a battery and a separate array, the controller is what protects the most expensive component and determines how much of the array's output actually reaches storage.
What to check before ordering
The checks below apply to any charge controller. Run them against the specification table above — most disappointing solar purchases are compatible-on-paper units that fail one of these in practice.
- Confirm the controller supports your battery chemistry with the right charge profile. Lithium, AGM, gel and flooded batteries need different absorption and float voltages.
- Prefer a unit with temperature compensation or a battery temperature sensor if the bank lives somewhere that gets hot or cold.
- Choose MPPT over PWM for anything beyond a very small array. An MPPT controller harvests roughly 20–30% more energy because it converts excess panel voltage into charge current instead of throwing it away.
- Size the current rating from array watts divided by battery voltage, then add at least 25% margin for cold, bright conditions where panels exceed their rated output.
What people get wrong
- Sizing on rated array watts alone and ignoring the voltage ceiling, which is the most common way controllers are killed.
- Using a PWM controller with a high-voltage grid-tie panel — the voltage mismatch wastes a large share of the panel's output.
- Running the load output beyond its rating instead of wiring heavy loads directly to the battery through a fuse.
Price and availability
MIDNITE Classic 200 MPPT Charge Controller is listed at ₨ 80,000 (PKR). Solar pricing moves with supply, import duties and exchange rates, and distributors set their own margins, so treat this as a comparison reference and confirm the current figure before you order.
SolarBazaar compares equipment rather than selling it. Shortlist here on specification and price, then buy from an authorised distributor or installer in your country: warranty cover on solar hardware is normally honoured through the channel you bought from, so confirm who supports MIDNITE Classic locally before ordering.
MIDNITE Classic 200 MPPT Charge Controller — frequently asked questions
How much does MIDNITE Classic 200 MPPT Charge Controller cost?
MIDNITE Classic 200 MPPT Charge Controller is listed at ₨ 80,000 (PKR). The figure is indicative — solar prices move with supply, duties and exchange rates, and each distributor sets its own margin — so confirm the current price with a supplier before ordering.
What are the specifications of MIDNITE Classic 200 MPPT Charge Controller?
We hold 6 published specifications for this charge controller, including battery voltage Charge: 12-93 Volts, derated current at 40°C (104°F): 66 Amps, current output Max at 25°C (77°F): 74A @ 12V | 70A @ 24V | 65A @ 48V, environment -40°C to 40°C (-40°F to 104°F) and input voltage Operating: 200VDC. The full table is on this page, listed under model SCMN-02.
Who makes MIDNITE Classic 200 MPPT Charge Controller?
MIDNITE Classic 200 MPPT Charge Controller is a MIDNITE Classic product, listed under charge controllers with model reference SCMN-02. The MIDNITE Classic brand page lists the rest of its range so you can compare across the catalogue.
Is MIDNITE Classic 200 MPPT Charge Controller right for my system?
That depends on what it has to connect to. For a charge controller, check whether it offers a load output, temperature compensation and remote monitoring, type: MPPT or PWM and rated charge current in amps, which must exceed the array's short-circuit current with margin against the rest of your equipment before price enters the decision. Confirm the controller supports your battery chemistry with the right charge profile. Lithium, AGM, gel and flooded batteries need different absorption and float voltages.
Where can I buy MIDNITE Classic 200 MPPT Charge Controller?
SolarBazaar lists and compares equipment rather than selling it. Use the specifications and price here to shortlist, then buy through an authorised distributor or installer — buying in-channel is what keeps the manufacturer's warranty valid.
Reviews
No reviews yet
Be the first to review this product.
Write a Review
Share your experience — no account needed.
