Charge Controllers
Charge Controllers
BrandVictron Energy
Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth)
$ 62.05USD · price may vary
BrandVictron Energy- Model
- SCC075010060R
- Specifications
- 0
Overview
A solar charger gathers energy from your solar panels, and stores it in your batteries. Using the latest, fastest technology, SmartSolar maximises this energy-harvest, driving it intelligently to achieve full charge in the shortest possible time. SmartSolar maintains battery health, extending its life.
The SmartSolar charge controller will even recharge a severely depleted battery. It can operate with a battery voltage as low as 0 Volts, provided the cells are not permanently sulphated or otherwise damaged.
Bluetooth Smart built-in
The wireless solution to set-up, monitor, update and synchronise SmartSolar Charge Controllers.
VE.Direct - For a wired data connection to a Color Control GX, other GX products, PC or other devices
Ultra-fast Maximum Power Point Tracking (MPPT)
Especially in case of a clouded sky, when light intensity is changing continuously, an ultra-fast MPPT controller will improve energy harvest by up to 30 % compared to PWM charge controllers and by up to 10 % compared to slower MPPT controllers.
Load output
Over-discharge of the battery can be prevented by connecting all loads to the load output. The load output will disconnect the load when the battery has been discharged to a pre-set voltage (48 V model: interface with a relay). Alternatively, an intelligent battery management algorithm can be chosen: see Battery Life. The load output is short circuit proof.
Battery Life: intelligent battery management
When a solar charge controller is not able to recharge the battery to its full capacity within one day, the result is often that the battery will continually be cycled between a ‘partially charged’ state and the ‘end of discharge’ state. This mode of operation (no regular full recharge) will destroy a lead-acid battery within weeks or months. The Battery Life algorithm will monitor the state of charge of the battery and, if needed, day by day slightly increase the load disconnect level (i.e. disconnect the load earlier) until the harvested solar energy is sufficient to recharge the battery to nearly the full 100 %. From that point onwards, the load disconnect level will be modulated so that a nearly 100 % recharge is achieved about once every week.
Programmable battery charge algorithm - See the software section on our website for details
Day/night timing and light dimming option - See the software section on our website for details
Internal temperature sensor - Compensates absorption and float charge voltage for temperature.
Optional external battery voltage and temperature sensing via Bluetooth
A Smart Battery Sense or a BMV-712 Smart Battery Monitor can be used to communicate battery voltage and temperature to one or more SmartSolar Charge Controllers.
Fully discharged battery recovery function
Will initiate charging even if the battery has been discharged to zero volts. Will reconnect to a fully discharged Li-ion battery with integrated disconnect function.
Specifications
Battery voltage (auto select): 12/24V
Rated charge current: 10A
Nominal PV Power, 12V 1a,b: 145W
Nominal PV Power, 24V 1a,b: 290W
Max. PV short circuit current 2: 13A
Max. PV open circuit voltage: 75V
Peak efficiency: 98%
Weight: 0.5kg
Dimensions (hxwxd): 100 x 113 x 40mm
Still Have Questions About Victron Energy SmartSolar? Give us a call today 1-877-242-2792
What these specifications mean
Detailed specifications for Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) have not been published yet. Victron Energy lists this charge controller in the Charge Controllers, and we add fields as the manufacturer releases them — in the meantime, ask your distributor for the datasheet before ordering.
For a charge controller, the figures that matter most are conversion efficiency, typically 96–99% for a good MPPT unit, whether it offers a load output, temperature compensation and remote monitoring, type: MPPT or PWM and rated charge current in amps, which must exceed the array's short-circuit current with margin. In any system with a battery and a separate array, the controller is what protects the most expensive component and determines how much of the array's output actually reaches storage.
Choosing a charge controller: the checks that matter
The checks below apply to any charge controller. Run them against the specification table above — most disappointing solar purchases are compatible-on-paper units that fail one of these in practice.
- Size the current rating from array watts divided by battery voltage, then add at least 25% margin for cold, bright conditions where panels exceed their rated output.
- Check the maximum PV input voltage against the array's Voc at your coldest expected temperature, not at 25 °C — Voc rises as temperature falls, and exceeding the limit destroys the controller instantly.
- Confirm the controller supports your battery chemistry with the right charge profile. Lithium, AGM, gel and flooded batteries need different absorption and float voltages.
- Prefer a unit with temperature compensation or a battery temperature sensor if the bank lives somewhere that gets hot or cold.
What people get wrong
- Sizing on rated array watts alone and ignoring the voltage ceiling, which is the most common way controllers are killed.
- Using a PWM controller with a high-voltage grid-tie panel — the voltage mismatch wastes a large share of the panel's output.
- Running the load output beyond its rating instead of wiring heavy loads directly to the battery through a fuse.
Price and availability in Saudi Arabia
Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) is listed at $ 62 (USD) for Saudi Arabia. Solar pricing moves with supply, import duties and exchange rates, and distributors set their own margins, so treat this as a comparison reference and confirm the current figure before you order.
SolarBazaar compares equipment rather than selling it. Shortlist here on specification and price, then buy from an authorised distributor or installer in Saudi Arabia: warranty cover on solar hardware is normally honoured through the channel you bought from, so confirm who supports Victron Energy locally before ordering.
Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) — frequently asked questions
How much does Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) cost?
Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) is listed at $ 62 (USD) for Saudi Arabia. The figure is indicative — solar prices move with supply, duties and exchange rates, and each distributor sets its own margin — so confirm the current price with a supplier before ordering.
Who makes Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth)?
Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) is a Victron Energy product, listed under charge controllers with model reference SCC075010060R. The Victron Energy brand page lists the rest of its range so you can compare across the catalogue.
Is Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) right for my system?
That depends on what it has to connect to. For a charge controller, check conversion efficiency, typically 96–99% for a good MPPT unit, whether it offers a load output, temperature compensation and remote monitoring and type: MPPT or PWM against the rest of your equipment before price enters the decision. Prefer a unit with temperature compensation or a battery temperature sensor if the bank lives somewhere that gets hot or cold.
Where can I buy Victron Energy SmartSolar MPPT 75V 10 amp 12/24-Volt Solar Charge Controller (Bluetooth) in Saudi Arabia?
SolarBazaar lists and compares equipment rather than selling it. Use the specifications and price here to shortlist, then buy through an authorised distributor or installer in Saudi Arabia — buying in-channel is what keeps the manufacturer's warranty valid.
Reviews
No reviews yet
Be the first to review this product.
Write a Review
Share your experience — no account needed.
