Batteries

SunMaxx Battery Charger 30A

₨ 4,000PKR · price may vary

Model: SUNX-06
Specifications: 3

Battery Charging VoltageDC 12V
Charge Current30A
Input Voltage230V AC

Overview

OVERVIEW:Switch Mode Battery Charging thus minimizing power dissicipation over a wide range of AC Adapter Voltages i.e. energy saving and reduce electric bills due to low power consumtion for chargingAutomatic Shut off FunctionOn-Off Switch for manual controlling of chargingFull Amperes GuaranteedAn

Specifications

General Specification
Battery Charging Voltage	DC 12V
Charge Current	30A
Input Voltage	230V AC

What these specifications mean

SunMaxx Battery Charger 30A is listed with 3 published specifications from SunMaxx, including battery charging voltage of DC 12V, charge current of 30A and input voltage of 230V AC. Those figures are what decide whether this unit fits your system, so read them against the equipment it will connect to before comparing price.

For a battery, the figures that matter most are nominal capacity in ampere-hours (Ah) or kilowatt-hours (kWh), usable capacity after depth of discharge — LiFePO4 typically allows 80–100%, lead-acid closer to 50%, system voltage: 12 V, 24 V and 48 V for low-voltage packs, or a high-voltage stack and continuous charge and discharge current, which limits how much power you can draw from the pack. Storage is what turns a solar array from a daytime bill-reducer into a system that covers evening loads and rides through outages. It is normally the single most expensive component, so sizing it correctly matters more than with any other part.

Before you buy a battery

The checks below apply to any battery. Run them against the specification table above — most disappointing solar purchases are compatible-on-paper units that fail one of these in practice.

Compare usable kilowatt-hours, not nameplate capacity. A 100 Ah lead-acid battery at 12 V is nominally 1.2 kWh but only about 0.6 kWh is safely usable, while a 100 Ah LiFePO4 pack gives you roughly 1.0–1.2 kWh.
Size from your evening consumption. Add up what actually runs after sunset for the hours you want covered, then divide by the usable capacity per unit — that number, not the array size, sets how many batteries you need.
Check the continuous discharge rating against your inverter. A battery that stores plenty of energy but can only deliver 50 A cannot support a large inverter at full output.
Match voltage to the inverter, and confirm the battery appears on the inverter maker's supported list. Closed-loop communication lets the inverter respect the battery's real charge limits instead of guessing.

Where buyers lose money

Ignoring the charge current limit and pairing a large array with a small bank, which trips protection and shortens life.
Mixing old and new batteries, or different chemistries, in one bank. The weakest unit drags the whole bank down and can be damaged by the others.
Sizing the bank for total daily consumption rather than after-dark consumption, which typically doubles the cost for no benefit.

Price and availability

SunMaxx Battery Charger 30A is listed at ₨ 4,000 (PKR). Solar pricing moves with supply, import duties and exchange rates, and distributors set their own margins, so treat this as a comparison reference and confirm the current figure before you order.

SolarBazaar compares equipment rather than selling it. Shortlist here on specification and price, then buy from an authorised distributor or installer in your country: warranty cover on solar hardware is normally honoured through the channel you bought from, so confirm who supports SunMaxx locally before ordering.

SunMaxx Battery Charger 30A — frequently asked questions

How much does SunMaxx Battery Charger 30A cost?

SunMaxx Battery Charger 30A is listed at ₨ 4,000 (PKR). The figure is indicative — solar prices move with supply, duties and exchange rates, and each distributor sets its own margin — so confirm the current price with a supplier before ordering.

What are the specifications of SunMaxx Battery Charger 30A?

We hold 3 published specifications for this battery, including battery charging voltage DC 12V, charge current 30A and input voltage 230V AC. The full table is on this page, listed under model SUNX-06.

Who makes SunMaxx Battery Charger 30A?

SunMaxx Battery Charger 30A is a SunMaxx product, listed under batteries with model reference SUNX-06. The SunMaxx brand page lists the rest of its range so you can compare across the catalogue.

Is SunMaxx Battery Charger 30A right for my system?

That depends on what it has to connect to. For a battery, check round-trip efficiency, around 90–95% for lithium and 75–85% for lead-acid, communication protocol (CAN or RS485) for talking to the inverter and nominal capacity in ampere-hours (Ah) or kilowatt-hours (kWh) against the rest of your equipment before price enters the decision. Leave room to expand. Packs that parallel cleanly let you add capacity later; ones that do not force a full replacement.

Where can I buy SunMaxx Battery Charger 30A?

SolarBazaar lists and compares equipment rather than selling it. Use the specifications and price here to shortlist, then buy through an authorised distributor or installer — buying in-channel is what keeps the manufacturer's warranty valid.

Reviews

No reviews yet

Be the first to review this product.