Charge Controllers

MIDNITE Classic 150 MPPT Charge Controller

₨ 80,000PKR · price may vary

Model: SCMN-01
Specifications: 7

Output CurrentMax (Battery): 96.00 Amps
Input CurrentMax (PV): 96.00 Amps
Input VoltageMax (PV): 150.00 Volts
Battery Voltage12 Volts
TechnologyMPPT
View all 7 specifications ↓

Size your system More from MIDNITE Classic

Overview

OVERVIEW:The Classic 150 MPPT Charge Controller is MidNite Solar's most popular model. It has Arc Fault, Ground Fault, free web monitoring, a graphics panel, and Solar, Hydro, and Wind Modes. The Classic 150 has a maximum output current of 96 amps, an operating voltage of 150 volts, and works with 1

Specifications

Summary
Output Current	Max (Battery): 96.00 Amps
HARDWARE FEATURES
Input Current	Max (PV): 96.00 Amps
Input Voltage	Max (PV): 150.00 Volts
TECHNICAL SPECIFICATION
Battery Voltage	12 Volts
General Specification
Technology	MPPT
Weight	12 lb
Dimensions	19 in (length) × 8.5 in (width) × 6 in (height)

What these specifications mean

MIDNITE Classic 150 MPPT Charge Controller is listed with 7 published specifications from MIDNITE Classic, including output current of Max (Battery): 96.00 Amps, input current of Max (PV): 96.00 Amps, input voltage of Max (PV): 150.00 Volts and battery voltage of 12 Volts. Those figures are what decide whether this unit fits your system, so read them against the equipment it will connect to before comparing price.

For a charge controller, the figures that matter most are rated charge current in amps, which must exceed the array's short-circuit current with margin, maximum PV open-circuit voltage, the hard limit that must survive cold-morning Voc rise, supported battery voltages (12/24/36/48 V) and chemistries and conversion efficiency, typically 96–99% for a good MPPT unit. In any system with a battery and a separate array, the controller is what protects the most expensive component and determines how much of the array's output actually reaches storage.

Choosing a charge controller: the checks that matter

The checks below apply to any charge controller. Run them against the specification table above — most disappointing solar purchases are compatible-on-paper units that fail one of these in practice.

Choose MPPT over PWM for anything beyond a very small array. An MPPT controller harvests roughly 20–30% more energy because it converts excess panel voltage into charge current instead of throwing it away.
Size the current rating from array watts divided by battery voltage, then add at least 25% margin for cold, bright conditions where panels exceed their rated output.
Check the maximum PV input voltage against the array's Voc at your coldest expected temperature, not at 25 °C — Voc rises as temperature falls, and exceeding the limit destroys the controller instantly.
Confirm the controller supports your battery chemistry with the right charge profile. Lithium, AGM, gel and flooded batteries need different absorption and float voltages.

Where buyers lose money

Sizing on rated array watts alone and ignoring the voltage ceiling, which is the most common way controllers are killed.
Using a PWM controller with a high-voltage grid-tie panel — the voltage mismatch wastes a large share of the panel's output.
Running the load output beyond its rating instead of wiring heavy loads directly to the battery through a fuse.

Price and availability in Pakistan

MIDNITE Classic 150 MPPT Charge Controller is listed at ₨ 80,000 (PKR) for Pakistan. Solar pricing moves with supply, import duties and exchange rates, and distributors set their own margins, so treat this as a comparison reference and confirm the current figure before you order.

SolarBazaar compares equipment rather than selling it. Shortlist here on specification and price, then buy from an authorised distributor or installer in Pakistan: warranty cover on solar hardware is normally honoured through the channel you bought from, so confirm who supports MIDNITE Classic locally before ordering.

MIDNITE Classic 150 MPPT Charge Controller — frequently asked questions

How much does MIDNITE Classic 150 MPPT Charge Controller cost?

MIDNITE Classic 150 MPPT Charge Controller is listed at ₨ 80,000 (PKR) for Pakistan. The figure is indicative — solar prices move with supply, duties and exchange rates, and each distributor sets its own margin — so confirm the current price with a supplier before ordering.

What are the specifications of MIDNITE Classic 150 MPPT Charge Controller?

We hold 7 published specifications for this charge controller, including output current Max (Battery): 96.00 Amps, input current Max (PV): 96.00 Amps, input voltage Max (PV): 150.00 Volts, battery voltage 12 Volts and technology MPPT. The full table is on this page, listed under model SCMN-01.

Who makes MIDNITE Classic 150 MPPT Charge Controller?

MIDNITE Classic 150 MPPT Charge Controller is a MIDNITE Classic product, listed under charge controllers with model reference SCMN-01. The MIDNITE Classic brand page lists the rest of its range so you can compare across the catalogue.

Is MIDNITE Classic 150 MPPT Charge Controller right for my system?

That depends on what it has to connect to. For a charge controller, check supported battery voltages (12/24/36/48 V) and chemistries, conversion efficiency, typically 96–99% for a good MPPT unit and whether it offers a load output, temperature compensation and remote monitoring against the rest of your equipment before price enters the decision. Size the current rating from array watts divided by battery voltage, then add at least 25% margin for cold, bright conditions where panels exceed their rated output.

Where can I buy MIDNITE Classic 150 MPPT Charge Controller in Pakistan?

SolarBazaar lists and compares equipment rather than selling it. Use the specifications and price here to shortlist, then buy through an authorised distributor or installer in Pakistan — buying in-channel is what keeps the manufacturer's warranty valid.

Reviews

No reviews yet

Be the first to review this product.